1. Center Bolt 2. Hub Bolt 3. Hub Assembly 4. Snap Ring |
5. Pulley 6. Compressor Assembly 7. Electric Control Valve (ECV) |
Waveform
This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft
Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition
timing by using these sig ...
Steering Column and Shaft Adjustment
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below and if abnormal symp ...
AGM Battery: Inspection
Battery Diagnostic Flow
Vehicle parasitic current inspection
1.
Turn all the electric devices OFF, and then turn the ignition
switch OFF.
...