Kia Rio: Delivery Pipe Removal
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be injury caused by
leakage of the high pressure fuel. Before repairing the high pressure
system, be sure to release the residual pressure in fuel line as step
2 in below procedure.
|
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
|
2. |
Release the residual pressure in fuel line (Refer to the Fuel
Delivery System - Repair Procedures - "Release Residual Pressure in
Fuel Line").
When removing the fuel pump relay, a Diagnostic Trouble
Code (DTC) may occur. Delete the code with the GDS after completion
of “Release Residual Pressure in Fuel Line” work.
|
|
3. |
Remove the intake manifold (Refer to "Intake And Exhaust System"
in EM group).
|
|
4. |
Disconnect the injector connectors (A) and the rail pressure sensor
connector (B).
|
|
5. |
Remove the high pressure fuel pipe (C).
|
|
6. |
Remove the engine oil gauge.
|
|
7. |
Remove the installation bolt (D), and then remove the delivery
pipe and injector assembly from the engine.
|
1.
Installation is reverse of removal.
Accelerator pedal module installation
nut:
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb- ...
•
Do not use already used injector fixing clip again.
...
See also:
Trouble Symptom Charts
Trouble Symptom 1
Trouble Symptom 2
Trouble symptom
Probable cause
Remedy
The set vehicle speed varies greatly upward or downward
"Surgin ...
Installation
1.
Install in the reverse order of removal.
2.
Adjust the alternator belt tension after installation.
(Refer to Engine charging Sy ...
Installation
Installation is the reverse of removal.
Canister installation bolt/nut:
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)
...
Accelerator Pedal Installation
Delivery Pipe Installation