Kia Rio: Driver Airbag (DAB) Module and Clock Spring Removal

Set the front tires straight-ahead before removing the steering wheel.

If the steering wheel and the front tires are not set straight ahead together, it affects the number of circulation of steering wheel and the cable inside the clock spring is possible to be damaged.

Disconnect the battery negative cable.

After disconnecting the battery negative cable, wait for at least thirty seconds.

Release the connector locking pin, then disconnect the driver airbag module connector (B).

The removed airbag module should be stored in a clean, dry place with the pad cover facing up.

4.	Remove the steering wheel and steering wheel column shroud. (Refer to the Steering System group - "Steering Column and Shaft")

5.	Disconnect the clock spring and horn connector (A), then remove the clock spring.

Driver Airbag (DAB) Module and Clock Spring Components

1. Driver Airbag (DAB) 2. Steering Wheel 3. Clock Spring ...

Driver Airbag (DAB) Module and Clock Spring Inspection

Driver Airbag (DAB) If any improper parts are found during the following inspection, replace the airbag module with a new one. ...

Removal
1. Disconnect the battery terminal (A). 2. Remove the air duct and air cleaner assembly. (Refer to Engine Mechanical System - & ...

Specifications
Item Specifications Transmission type A6GF1 Engine model Gasoline 1.6 GDI Torque converter type 3-element, 1-stage, 2-phas ...

Front Driveshaft Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) fro ...