Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Removal - Battery - Charging System - Engine Electrical System - Kia Rio UB 2012-2020 Service ManualKia Rio: Removal

1.
Disconnect the battery terminal (A).
2.
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
3.
Remove the battery mounting bracket and the insulation pad (A), and then remove the battery(B).
4.
Disconnect the ECM connector (A), and then remove ECM (B) after removing the bolts/nut.
5.
Remove the battery tray (C) after removing the bolts.


Adjustment
Battery charging In general, vehicle battery charging system has three forms. 1. Constant current charge: The battery voltage gradually rises by chargi ...
Installation
1. Install in the reverse order of removal. Battery (-)terminal installation [with battery sensor] : 4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf. ...
See also:

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least thirty seconds. ...

Description
Idle Stop & Go (ISG) function automatically switches off the engine when the car is at a standstill if the and starts it again as soon as the brake pedal is released. This not only reduce ...

TPMS Sensor Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driv ...

Copyright © www.kiamanual.com 2020-2021