Kia Rio: Adjustment
| Battery charging |
In general, vehicle battery charging system has three forms.
|
1. |
Constant current charge: The battery voltage gradually rises by
charging with setting a constant current. If charging current and time
are not managed correctly, the battery is over-charged, therefore charging
should be stopped after confirming the completion of charging.
|
| A.
General charge: Charging the battery for a long time with
low current
|
| B.
Quick charge: Charging the battery for a short time with
high current
|
|
2. |
Constant voltage charge: The battery charge current is gradually
reduced by charging with setting a constant voltage.
|
|
3. |
Constant current-Constant voltage charge: Charging with constant
current and voltage to protect the battery damage
|
|
(1) |
Initial Stage: Charging with constant current
|
|
(2) |
Last Stage: Charging with constant voltage
Refer to the instruction manual provided by the
battery charger equipment manufacturers for detailed
charging procedures and precautions.
|
[AGM battery charging]
AGM battery should be charged with constant voltage or constant current-constant
voltage in order to minimize performance degradation due to the charging.
If charging the battery with constant current, overcharging may occur.
It can cause damage to the internal battery and will give an adverse effect
on battery life.
Do not charge with more than 14.8V or quick charge mode.
[Constant voltage charge conditions]
Charging voltage / time:
14.7V [68°F ~ 86°F (20°C ~ 30°C)] / approximately 24 hours
The minimum charge voltage:
14.4V [68°F ~ 86°F (20°C ~ 30°C)]
The maximum charging voltage:
14.8V [68°F ~ 86°F (20°C ~ 30°C)]
|
Battery temperature should be maintained at about 68°F ~ 86°F
(20°C ~ 30°C) during charging of the battery.
If the battery is charged directly at the battery terminals on
vehicles with battery sensor, misinterpretations of battery condition
and under certain circumstances also unwanted Check Control messages
or fault memory entire can occur.
After recharging finished, let the battery stand for over 10 hours
with normal temperature for battery stabilization.
eration DC (2001-2005)
1. Battery (Non-ISG Type)
2. Battery (ISG Type)
3. Battery tray
4. Battery insulation pad
5. Battery mounting bracket
...
1.
Disconnect the battery terminal (A).
2.
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - & ...
See also:
Electric Oil Pump: Description
This transaxle has a standard Mechanical Oil Pump (MOP) linked to the
input shaft to generates oil pressure when input shaft rotates.
But, this transaxle equipped with ISG system also has ...
Back-up Lamp Switch Specifications
1.
Working voltage: DC 10~15V
2.
Operating force: 3.0kg Max.
3.
Voltage drop: - 0.4V
4. ...
Ignition Coil: Inspection
1.
Measure the primary coil resistance between terminals (+) and
(-).
Standard value:
0.75Ω ± 15%
...
Components
Removal