Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Dynamic Damper Installation - Driveshaft Assembly - Driveshaft and axle - Kia Rio UB 2012-2020 Service ManualKia Rio: Dynamic Damper Installation

1.
Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper.
2.
Install the dynamic damper.
3.
Install the dynamic damper band.
4.
Using the SST(09495-3K000), secure the TJ boot bands (A).
Clearance (A): 2.0 mm (0.079 in) or less


5.
Install the TJ joint assembly. (Refer to DS group - “TJ joint”)
6.
Install the front driveshaft. (Refer to DS group - “Front Driveshaft”)
Dynamic Damper Replacement
1. Remove the front driveshaft. (Refer to DS group - “Front Driveshaft”) 2. Remove the TJ joint assembly. (Refer to DS group - “TJ joint”) ...
BJ Boot Components
1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 1 ...
See also:

Head lamp leveling Actuator Installation
1. Install the head lamp leveling actuator by turning the adjusting gear. 2. Install the head lamp assembly. 3. ...

SS-A Solenoid Valve(ON/OFF) Installation
1. Installation is the reverse of removal.    • When installing, ...

Photo Sensor (FATC only) Inspection
1. Turn the ignition switch ON. 2. Connect the GDS. 3. Emit intensive light toward photo sensor using a lamp, a ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts