Kia Rio: General Service Information
Protection Of The Vehicle
Always be sure to cover fenders, seats, and floor areas before starting
work.
The support rod must be inserted into the hole near the edge of
the hood whenever you inspect the engine compartment to prevent the
hood from falling and causing possible injury.
Make sure that the support rod has been released prior to closing
the hood. Always check to be sure the hood is firmly latched before
driving the vehicle.
There are five primary symbols used to complement illustrations. These
symbols indicate the part to apply such materials during service.
Symbol
Meaning
...
Be sure that all necessary tools and measuring equipment are available
starting work.
Special Tools
Use special tools when they are required.
Removal Of Parts
First find the cause ...
See also:
Installation
•
Install the component with the specified torques.
•
...
Condenser Inspection
1.
Check the condenser fins for clogging and damage. If clogged,
clean them with water, and blow them with compressed air. If bent, gently
bend them using a screwdrive ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the purge control solenoid valve connector (A) ...