Kia Rio: Inspection
| Sprockets, Hydraulic Tensioner, Chain
Guide, Tensioner Arm |
|
1. |
Check the CVVT sprocket, crankshaft sprocket teeth for abnormal
wear, cracks or damage. Replace if necessary.
|
|
2. |
Check a contact surface of the chain tensioner arm and guide for
abnormal wear, cracks or damage. Replace if necessary.
|
|
3. |
Check the hydraulic tensioner for its piston stroke and ratchet
operation. Replace if necessary.
|
Belt, Idler, Pulley
|
1. |
Check the idler for excessive oil leakage, abnormal rotation or
vibration. Replace if necessary.
|
|
2. |
Check belt for maintenance and abnormal wear of V-ribbed part.
Replace if necessary.
|
|
3. |
Check the pulleys for vibration in rotation, oil or dust deposit
of V-ribbed part. Replace if necessary.
|
|
•
Do not bend, twist or turn the timing chain inside
out.
|
|
•
Do not allow the timing chain to come into contact
with oil, water and steam.
|
Engine removal is not required for this procedure.
•
Use fender covers to avoid damaging pa ...
1.
Dowel pin of crankshaft setted about 3° with vertical center line.
2.
Align the TDC marks (A) of the CVVT sprockets with the upper su ...
See also:
Cleaning
1.
Make sure the ignition switch and all accessories are in the OFF
position.
2.
Disconnect the battery cables (negative first).
...
Temperature Control Actuator Description
The heater unit includes mode control actuator and temperature control
actuator.
The temperature control actuator is located at the heater unit. It regulates
the temperature by the proced ...
Temperature Control Actuator Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver side shower duct (A) after loosening the screw.
...
Removal
Installation