Kia Rio: Inspection

Clutch Pedal Inspection

Measure the clutch pedal height (from the face of the pedal pad to the floorboard) and the clutch pedal clevis pin play (measured at the face of the pedal pad.)

Standard value

Stroke (A): 140 mm (5.5118 in.)

Free play (B): 6 ~ 13 mm (0.2362 ~ 0.5118 in.)

Height (C): 178 mm (7.0079 in.)

Ignition Lock Switch Inspection

1.	Disconnect 2P-connector from a ignition lock switch.

2.	Disconnect the ignition lock switch. (if you can install a tester with the switch fixed, this step can be omissible)

Check for continuity between terminals. (refer to the table below)

•	If there is difference between what tested and the table above, replace the ignition lock switch with a new one.

Pedal position	Clutch switch	Ignition lock switch
Released	Pressed (Continuity)	Released (Open)
Fully pressed	Released (Open)	Pressed (Continuity)

Standard value

Full stroke (A): 12.0 ± 0.3mm (0.4724 ± 0.0118 in.)

ON-OFF point (B): 2.0 ± 0.3mm (0.0787 ± 0.0118 in)

4.	If there is difference between what tested and the table above, replace the ignition lock switch with a new one.

Components

1. Master cylinder 2. Ignition lock switch 3. Clutch switch 4. Pedal pad ...

Removal

• Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does c ...

Kia Rio: Inspection

Components

Removal

See also: