Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Inspection - Rear Disc Brake - Brake System - Kia Rio UB 2012-2020 Service ManualKia Rio: Inspection

Rear Brake Disc Thickness Check
1.
Check the brake pads for wear and fade.
2.
Check the brake disc for damage and cracks.
3.
Remove all rust and contamination from the surface, and measure the disc thickness at 12 points, at least, of same distance (5mm) from the brake disc outer circle.

Brake disc thickness
Standard: 10 mm (0.394 in)
Service limit: 8.4 mm (0.331 in)
Deviation: less than 0.005 mm (0.0002 in)


4.
If wear exceeds the limit, replace the discs and pad assembly left and right of the vehicle.
Rear Brake Pad Check
1.
Check the pad wear. Measure the pad thickness and replace it, if it is less than the specified value.

Pad thickness
Standard value: 10 mm (0.394 in)
Service limit: 2.0 mm (0.0787 in)

2.
Check that grease is applied, to sliding contact points. Check for metal damage to the pad and backing.
Replacement
Rear Brake Pads 1. Loosen the guide rod bolt (B) and then remove the rear caliper body (A). Tightening torque: 21.6 ~ 31 ...
Installation
1. Installation is the reverse of removal. 2. Use a SST (09580-0U000) when installing the brake caliper assembly. ...
See also:

Installation
Multifunction Switch 1. Install the multifunction switch. 2. Install the clock spring. 3. Install the steer ...

SRS Control Module (SRSCM) Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

Rear Hub - Carrier Components
[Drum Type] 1. Rear torsion beam assembly 2. Brake assembly 3. Rear wheel hub assembly 4. Rear brake disc 5. Rear brake disc mounting screw ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts