Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Replacement - Rear Disc Brake - Brake System - Kia Rio UB 2012-2020 Service ManualKia Rio: Replacement

Rear Brake Pads
1.
Loosen the guide rod bolt (B) and then remove the rear caliper body (A).

Tightening torque:
21.6 ~ 31.4 N.m (2.2 ~ 3.2 kgf.m, 15.9 ~23.1 lb-ft)



     
Where necessary prevent the guide rods from rotating with an appropriate wrench.
Be careful not to damage the dust covers.
2.
Replace pad retainers (A) and brake pads (B) in the caliper carrier (C).



     
Clean the pad retainer surface at the caliper bracket.
Inspect the piston boots for damage and replace if necessary.
Check the smooth action of the guide rods, and their dust covers for damage.
Removal
1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...
Inspection
Rear Brake Disc Thickness Check 1. Check the brake pads for wear and fade. 2. Check the brake disc for damage and cracks. ...
See also:

Starter: Removal and Installation
1. Disconnect the battery negative terminal. 2. Remove the air duct and air cleaner assembly. (Refer to EM group) 3. ...

Components Location
1. Sub frame 2. Drive shaft 3. Lower arm 4. Strut assembly 5. Steering gearbox 6. Stabilizer bar ...

High Mounted stop lamp Removal
[4 Door] 1. Disconnect the negative (-) battery terminal. 2. Disconnect the connect (A). 3. Remove ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts