Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Starter: Removal and Installation - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Rio UB 2012-2020 Service ManualKia Rio: Starter: Removal and Installation

1.
Disconnect the battery negative terminal.
2.
Remove the air duct and air cleaner assembly. (Refer to EM group)
3.
Disconnect the starter cable (B) from the B terminal on the solenoid then disconnect the connector (A) from the S terminal.


4.
Remove the 2 bolts holding the starter, then remove the starter (A).

Tighting torque :
42.2 ~ 53.9 Nm (4.3 ~ 5.5 kgf.m, 31.1 ~ 39.8 lb-ft)


5.
Installation is the reverse of removal.
Starter: Description
The starting system includes the battery, starter, solenoid switch, inhibitor switch (A/T), ignition switch, ignition lock switch, connection wires and the battery cable. When the ignitio ...
Electric Oil Pump: Description
This transaxle has a standard Mechanical Oil Pump (MOP) linked to the input shaft to generates oil pressure when input shaft rotates. But, this transaxle equipped with ISG system also has ...
See also:

Climate Control Air Filtar Replacement
1. Open the glove box. 2. Remove the filter cover (A) by pressing the knob. 3. Replace the air filter ( ...

Inspection
Rear Brake Disc Thickness Check 1. Check the brake pads for wear and fade. 2. Check the brake disc for damage and cracks. ...

35R Clutch Control Solenoid Valve(35R/C_VFS) Removal
   Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts