Rio Car Manuals
Technical Info

Kia Rio: Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

1.

Installation is reverse of removal.

Rail Pressure Sensor Installation:

29.4 ~ 34.3 N.m (3.0 ~ 3.5 kgf.m, 21.7 ~ 25.3 lb-ft)

Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line (Refer to the ...

Accelerator Position Sensor (APS)

...

See also:

Power Mosfet (FATC) Inspection
1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of blower motor. 3. ...

Audio Remote Control Installation
1. Reassemble the steering wheel remote control switch after connecting the connector. 2. Reassemble the steering wheel. ...

Installation
1. Dowel pin of crankshaft setted about 3° with vertical center line. 2. Align the TDC marks (A) of the CVVT sprockets with the upper su ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts