Kia Rio: Removal
|
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
|
2. |
Release the residual pressure in fuel line (Refer to the Fuel
Delivery System - Repair Procedures - "Release Residual Pressure in
Fuel Line").
When removing the fuel pump relay, a Diagnostic Trouble
Code (DTC) may occur. Delete the code with the GDS after completion
of “Release Residual Pressure in Fuel Line” work.
|
|
3. |
Remove the intake manifold (Refer to “Intake And Exhaust System”
in EM group).
|
|
4. |
Disconnect the rail pressure sensor connector (A), and then remove
the sensor (B) from the delivery pipe.
|
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine
speed.
...
•
Install the component with the specified torques.
•
...
See also:
Components
1. Guide rod bolt
2. Bleed screw
3. Caliper carrier
4. Caliper body
5. Brake pad
6. Pad retainer
...
Passenger Airbag (PAB) Module Description
The passenger airbag (PAB) is installed inside the crash pad and protects
the front passenger in the event of a frontal crash. The SRSCM determines if
and when to deploy the PAB.
...
Description
The Evaporative Emission Control System prevents fuel vapor stored in
fuel tank from vaporizing into the atmosphere. When the fuel evaporates in the
fuel tank, the vapor passes through vent h ...
Inspection
Installation