Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Oil Pump Unit (OPU) Inspection - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Rio UB 2012-2020 Service ManualKia Rio: Oil Pump Unit (OPU) Inspection

OPU Problem Inspection Procedure
1.
TEST OPU GROUND CIRCUIT: Measure resistance between OPU and chassis ground using the backside of OPU harness connector as OPU side check point. If the problem is found, repair it.

Specification: Below 1Ω

2.
TEST OPU CONNECTOR: Disconnect the OPU connector and visually check the ground terminals on OPU side and harness side for bent pins or poor contact pressure. If the problem is found, repair it.
3.
If problem is not found in Step 1 and 2, the OPU could be faulty. If so, make sure there were no DTC's before swapping the OPU with a new one, and then check the vehicle again. If DTC's were found, examine this first before swapping OPU.
4.
RE-TEST THE ORIGINAL OPU: Install the original OPU (may be broken) into a known-good vehicle and check the vehicle. If the problem occurs again, replace the original OPU with a new one. If problem does not occur, this is intermittent problem (Refer to “Intermittent Problem Inspection Procedure” in Basic Inspection Procedure

     
Refer to DTC manual code “P1775, P1777” to inspect oil pump unit.
Oil Pump Unit (OPU) Installation
1. Installation is the reverse of removal. ...
Brake Switch Description
The present brake switch is used as an input variable for the ISG function to detect bracke operation. ...
See also:

Installation
1. Installation is the reverse of removal. 2. After installation, bleed the brake system. (Refer to Brake system bleeding) ...

Output Speed Sensor Signal Waveform
Fig 1) Input/Output speed sensor at low speed Fig 2) Input/Output speed sensor at high speed ...

Audio Remote Control Schematic Diagrams
Circuit Diagram (1) Circuit Diagram (2) ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts