Kia Rio: Rear Wiper Motor Inspection

Rear Wiper Motor

1.	Remove the 4P connector from the rear wiper motor.

2.	Connect battery positive (+) and negative (-) cables to terminals 4 and 1 respectively.

Check that the motor operates normally. Replace the motor if it operates abnormally.

Pin No.	Description
1	Battery +
2	-
3	Switch
4	Ground

Automatic Stop Operation Check

1.	Operate the motor at low speed using the stalk control.

2.	Stop the motor operation anywhere except at the off position by disconnecting terminal 3.

3.	Connect terminals 2 and 3.

4.	Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 4.

5.	Check that the motor stops running at the off position.

Rear Wiper Motor Installation

1. Install the rubber packing. 2. Install the rear wiper motor assembly. Tightening torque : 6.86 ~ 9.81N ...

Rear Washer Switch Inspection

1. With the rear wiper & washer switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace t ...

Kia Rio: Rear Wiper Motor Inspection

Rear Wiper Motor Installation

Rear Washer Switch Inspection

See also: