Kia Rio: Rear Wiper Motor Installation

1.	Install the rubber packing.

Install the rear wiper motor assembly.

Tightening torque :

6.86 ~ 9.81N.m (0.7 ~ 1.0kgf.m, 5.0 ~ 7.2lb-ft)

3.	Intall the tailgate trim.

Install the rear wiper arm and rear wiper arm cap.

Tightening torque :

3.92 ~ 6.86N.m (0.4 ~ 0.7kgf.m, 2.9 ~ 5.0lb-ft)

Before installation, be sure that the rear wiper motor is in the park position.

Turn the wiper switch ON and OFF to allow the rear wiper motor to cycle and stop in the park position.

5.	Set the rear wiper blade to the lowest defogger heat line and tailgate glass.

1. Detach the wiper cap (A) and remove a nut (B). 2. Remove the rear wiper arm & blade (A). 3. ...

Rear Wiper Motor 1. Remove the 4P connector from the rear wiper motor. 2. Connect battery positive (+) and negative (-) cables to terminals ...