Kia Rio: Removal
When replacing the ECM, the vehicle equipped with immobilizer
must be performed the procedure as below.
[In the case of installing used ECM]
| 1.
Perform "Neutral mode" procedure with GDS. (Refer to "Immobilizer"
in BE group)
|
| 2.
Insert the key and turn it to the IGN ON and OFF position.
|
Then the ECM key register process is completed automatically.
[In the case of installing new ECM]
| -
Insert the key and turn it to the IGN ON and OFF position.
|
Then the ECM key register process is completed automatically.
|
1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
|
2. |
Disconnect the ECM Connector (A).
|
|
3. |
Remove the battery (Refer to "Charging System" in EM group).
|
|
4. |
Remove the mounting bolts and nut, and then remove the ECM bracket
assembly (A).
|
When replacing the ECM, the vehicle equipped with immobilizer
must be performed the procedure as below.
...
See also:
Troubleshooting
•
The battery must be in good condition and fully charged
for this troubleshooting.
...
Specification
Pressure [kPa (kgf/cm², in H2O)
Output Voltage (V)
-6.67 (-0.068, -26.8)
0.5
0
2.5
+6.67 (0.068, 26.8)
4.5
...
Specification
...
Circuit Diagram
Installation