Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Removal - Parking Brake System - Brake System - Kia Rio UB 2012-2020 Service ManualKia Rio: Removal

Rear Disc Brake Type

     
The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature failure.
1.
Remove the floor console.
(Refer to Body group - "Floor console")
2.
Disconnect the connector (A) of parking brake switch.


3.
Loosen the adjusting nut (A) and the parking brake cables (B).



     
Parking brake lever in the car must be in fully loosened position.
4.
Remove the parking brake lever assembly after removing the bolts (A).


5.
Raise the vehicle, and make sure it is securely supported.
6.
Remove the rear tire and wheel.
7.
Remove the parking brake cable (A), after removing the clip (B).


8.
Loosen the parking brake cable bracket bolts and remove the parking brake cable.
Rear Drum Brake Type

     
The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature failure.
1.
Remove the floor console.
(Refer to Body group - "Floor console")
2.
Disconnect the connector (A) of parking brake switch.


3.
Loosen the adjusting nut (A) and the parking brake cables (B).



     
Parking brake lever in the car must be in fully loosened position.
4.
Remove the parking brake lever assembly after removing the bolts (A).


5.
Raise the vehicle, and make sure it is securely supported.
6.
Remove the rear tire and wheel.
7.
Remove the parking brake cable from the brake shoe. (Refer to the rear drum brake)
8.
Remove the parking brake cable (A), after removing the clip (B).


9.
Loosen the parking brake cable bracket bolts and remove the parking brake cable.
Components
1. Parking brake lever 2. Adjuster cable 3. Equalizer assembly 4. Parking brake cable ...
Installation
Rear Disc Brake Type 1. Install the parking brake cable. 2. Install the parking brake cable (A), and then install the clip (B ...
See also:

Seat Heater Inspection
Driver seat and Passenger seat 1. Check for continuity and measure the resistance between terminals. [Cushion] Pin No. ...

Troubleshooting
1. The lamp switch inputs can be checked using the GDS. 2. To check the input value of lamp switch, select option "Body Control Module ...

Blower Resistor (MANUAL) Inspection
1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replac ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts