Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Removal 
 - Manifold Absolute Pressure Sensor (MAPS) - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2020 Service ManualKia Rio: Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the manifold absolute pressure sensor connector (A).
3.
Remove the installation bolt (B), and then remove the sensor from the surge tank.


Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. Spe ...
Installation
   • Install the component with the specified torques. • ...
See also:

Dynamic Damper Replacement
1. Remove the front driveshaft. (Refer to DS group - “Front Driveshaft”) 2. Remove the TJ joint assembly. (Refer to DS group - “TJ joint”) ...

Blower Motor Inspection
1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substitute with a know ...

Transaxle Control Module (TCM) Terminal Function
Connector [EGGG-AA] Pin Description Pin Description 22 Shift solenoid D (VFS-OD) 73 Inhibitor switch signal "S4" ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts