Kia Rio: Seat Belt Buckle Switch (BS) Description

The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status input. The seat belt buckle circuit operates from internal boost voltage supplied by the SRSCM, and uses chassis ground for the signal return. The buckle status shall modify the SRSCM deployment. If the buckle status is unbuckled, the corresponding pretensioner will not be deactivated.

Side Impact Sensor (SIS) Installation

Pressure Side Impact Sensor 1. Install the new pressure side impact sensor with the screws (B) then connect the pressure side impact sensor connector (A). ...

Seat Belt Buckle Switch (BS) Components

...

See also:

Trunk Lid Replacement
Trunk Lid Assembly Replacement    • When removing and installing the trunk lid, an assistant ...

Antenna Coil Installation
1. Install the antenna coil. 2. Connect the antenna coil connector. 3. Install the crash pad lower panel. ...

Removal
   When replacing the ECM, the vehicle equipped with immobilizer must be performed the procedure as below. ...