Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Seat Belt Buckle Switch (BS) Installation - SRSCM - Restraint - Kia Rio UB 2012-2020 Service ManualKia Rio: Seat Belt Buckle Switch (BS) Installation


     
Be sure to install the harness wires so they will not pinch or interfere with other parts.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
3.
Install the seat belt buckle switch.

Tightening torque:
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb-ft)

4.
Install the front seat assembly.
(Refer to the Body group - "Front seat")
5.
Reconnect the battery negative cable.
6.
After installing the seat belt buckle switch, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.
Seat Belt Buckle Switch (BS) Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front seat assembly. ...
Weight Classification System (WCS) Description
WCS is intended to detect the occupant’s physique in order to determine whether the passenger airbag should be suppressed or deployed. WCS classifies the front passenger side seat by measurin ...
See also:

Auto Defogging Sensor (FATC only) Inspection
1. Press the MODE switch more then 4 times within 2 seconds while pressing the OFF switch. Display Fail description 00 ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the manifold absolute pressure sensor connecto ...

Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the output volt ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts