Kia Rio: Sunroof Replacement
Glass Replacement
|
Put on glove to protect your hands.
|
|
1. |
Remove the glass (A) by lifting it up.
|
|
Do not damage the roof panel.
|
|
2. |
Installation is the reverse of removal.
|
Motor Replacement
|
Confirm the position of guide whether it is closed or
not when you remove the motor.
|
|
1. |
Remove the roof trim.
(Refer to the BD group - "Roof Trim")
|
|
2. |
After loosening the mounting screws, then remove the motor assembly
(A).
|
|
3. |
Installation is the reverse of removal.
|
|
Make sure to initialize the motor.
|
Deflector Replacement
|
1. |
Open the glass fully.
|
|
2. |
After loosening the mounting screws, then remove the deflector
(A).
|
|
3. |
Installation is the reverse of removal.
|
Sunroof Assembly Replacement
|
1. |
Remove the follows parts :
|
| A.
Front seat
(Refer to the BD group - "Front seat")
|
| B.
Rear seat
(Refer to the BD group - "Rear seat")
|
| C.
Interior trim
(Refer to the BD group - "Interior Trim")
|
| D.
Roof trim
(Refer to the BD group - "Roof Trim")
|
| E.
Sunroof glass.
|
|
2. |
After loosening the mounting bolts, then remove the assist handle
bracket (A).
|
|
3. |
After loosening the mounting bolts, then remove the sunroof center
bracket (A).
|
|
4. |
Disconnect the drain tubes (B).
|
|
5. |
After loosening the mounding bolts and nuts, remove the sunroof
assembly (A).
Tightening torque:
(C) : 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
(D) : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
|
|
|
Take care not to scratch the interior trims and
other parts.
|
|
6. |
Installation is the reverse of removal.
|
|
Make sure to initialize the motor.
|
Sunshade Replacement
|
1. |
Remove the sunroof assembly.
|
|
2. |
Remove the sunshade stopper (B).
|
|
3. |
Remove the sunshade assembly (A).
|
|
4. |
Installation is the reverse of removal.
|
Guide Assembly Replacement
|
1. |
Remove the sunroof assembly.
|
|
2. |
Remove a drip link assembly (A) after lowering a guide thoroughly
by pushing a slide to rear.
|
|
3. |
Remove the guide (A) and drip link (B).
|
|
4. |
Remove the drip link stopper (B).
|
|
5. |
Remove the drip link assembly (A).
|
|
6. |
Installation is the reverse of removal.
|
|
Make sure to align the slide with the center of
(A) and (B)
|
|
Make sure to initialize the motor.
|
1 . Glass panel assembly
2 . Glass panel
3 . Reinforcement glass
4 . Encapsulated glass panel
5 . Wind deflector net assembly
6 . Wind deflector beam
7 . Plate cover [RH] ...
How To Initialize
1.
Check that the glass has been installed.
A.
Finished height adjustment.
2.
...
Sunroof Components
Sunroof Adjustment