Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Thermostat: Installation - Cooling System - Engine Mechanical System - Kia Rio UB 2012-2020 Service ManualKia Rio: Thermostat: Installation

1.
Place the thermostat in the block.
Install the thermostat (B) with the jiggle valve upward.
2.
Install the water inlet fitting (A).

Tightening torque :
18.6 ~ 23.5N.m (1.9 ~ 2.4kgf.m, 13.7 ~ 17.4lb-ft)


3.
Fill with engine coolant.
4.
Start engine and check for leaks.
Inspection
1. Immerse the thermostat in water and gradually heat the water. 2. Check the valve opening temperature. Valv ...
Thermostat: Troubleshooting
Symptoms Possible Causes Remedy Coolant leakage • From the thermostat gasket Check the mounting bo ...
See also:

Steering Angle Sensor (MDPS Only) Description
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turning directio ...

Replacement
Rear Brake Pads 1. Loosen the guide rod bolt (B) and then remove the rear caliper body (A). Tightening torque: 21.6 ~ 31 ...

Side Airbag (SAB) Module Components
...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts