Kia Cee'd: Engine Control System / Accelerator Position Sensor (APS) Repair procedures

Kia Cee'd JD Service Manual / Fuel System / Engine Control System / Accelerator Position Sensor (APS) Repair procedures

Inspection

1.	Connect the GDS on the Data Link Connector (DLC).

2.	Turn the ignition switch ON.

Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.

Specification: Refer to “Specification”

Removal

1.	Turn the ignition switch OFF and disconnect the negative (-) battery cable.

2.	Disconnect the accelerator position sensor connector (A).

3.	Remove the installation bolt (B) and nuts (C), and then remove the accelerator pedal module.

Installation

Installation is reverse of removal.

Accelerator pedal module installation nut:

12.7 ~ 19.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)

Accelerator pedal module installation bolt:

8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Accelerator Position Sensor (APS) Schematic diagrams

Circuit Diagram ...

Injector Description and operation

Description The GDI injector is similar to a standard injector, but sprays fuel at a much higher pressure directly into the combustion chamber and has a swirl disc to get the fue ...

Other information:

Kia Cee'd JD Service Manual: ESP Control Module Repair procedures
Removal [LHD] 1. Turn the ignition switch OFF. 2. Pull up the lock of the HECU connector (A) , then disconnect the connector. 3. Remove the brake fluid from the master cylinder reservoir with a ...

Kia Cee'd JD Owners Manual: Introduction
■ for 15 inch tire With the Tire Mobility Kit you stay mobile even after experiencing a tire puncture. The system of compressor and sealing compound effectively and comfortably seals most punctures in a passenger car tire caused by nails or similar objects and reinflates the tire ...