Kia Cee'd: Troubleshooting / Evaporator Temperature Sensor Repair procedures

Kia Cee'd JD Service Manual / Heating,Ventilation, Air Conditioning / Troubleshooting / Evaporator Temperature Sensor Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the evaporator temperature sensor connector.

3.	Measure resistance between terminal “+” and “-” of the evaporator temperature sensor.

4.	Connect the evaporator temperature sensor connector.

Run the engine and turn the A/C switch ON, then measure the voltage between the terminals of the harness connector.

Specification

Evaporator core temperature [°C(°F)]	Resistance [kΩ]	Voltage [V]
-20(-4)	70.04	3.50
-10(14)	43.35	2.96
0(32)	27.62	2.40
10(50)	18.07	1.88
20(68)	12.11	1.44
30(86)	8.30	1.08
40(104)	5.81	0.81
50(122)	4.15	0.61

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Disconnect the evaporator temperature sensor connector (A).

3.	Remove the evaporator temperature sensor (B) by pulling it out after rotating it 90° in a counterclockwise direction.

4.	Install in the reverse order of removal.

Evaporator Temperature Sensor Description and operation

Description The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by exc ...

In car sensor (DATC only) Description and operation

Description The In-car air temperature sensor is built in the heater & A/C control unit. The sensor contains a thermistor which measures the temperature of the inside. The ...

Other information:

Kia Cee'd JD Owners Manual: To turn off the speed limit control, do one of the following
Move the lever up (). Move the lever down (). (If you move the lever down, the cruise system will turn on) Turn the ignition off. If you press the O (CANCEL) button once, the set speed limit will cancel, but it will not turn the system off. If you wish to reset the speed l ...

Kia Cee'd JD Service Manual: Front Fog Lamps Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the lighting switch of the multifunction switch. (Refer to Multifunction Switch) 3. With the front fog lamp switch, make sure ...