Kia Cee'd: Lighting System / License Lamp Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / Lighting System / License Lamp Repair procedures

Removal

[5Door]

1.	Disconnect the negative (-) battery terminal.

2.	Remove the license lamp assembly after pushing the fixing clip (A).

3.	Replace the bulb (A) after removing the bulb socket (B).

[Wagon]

1.	Disconnect the negative (-) battery terminal.

2.	Using a screwdriver or remover, remove the rear combination lamp cover (A).

3.	Disconnect the rear combination lamp connector (A).

4.	Loosen the rear combination lamp mounting nuts (A).

5.	Remove the cover (A) after loosening the mounting nuts.

6.	Remove the rear combination lamp (A) after loosening the mounting nuts (B).

7.	Using the torch find the small clip (A) holding the number plate light in its position.

8.	With suitable and long enough screw driver press this clip gently and the light will jump out of position.

Remember that screw driver (A) has to be long enough to reach through the hole in the tail gate to the light clip inside.

Example is shown in the picture.

10.	With the screw driver press the clip (A).

11.	Remove the license lamp bulb (B) after removing the license lamp socket (A).

Installation

[5Door]

1.	Install the bulb and connect the connector.

2.	Install the license lamp.

[Wagon]

1.	Install the license lamp bulb and socket.

2.	Connect the license lamp connector.

3.	Install the rear combination lamp.

4.	Connect the rear combination lamp connector.

5.	Install the rear combination lamp cover.

6.	Connect the negative (-) battery terminal.

Overhead Console Lamp Repair procedures

Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map l ...

Hazard Lamp Switch Repair procedures

Inspection 1. It will be able to diagnose defects of hazard switch with GDS quickly. GDS can operates actuator forcefully, input/output value monitoring and ...

Other information:

Kia Cee'd JD Service Manual: ETC (Electronic Throttle Control) System Specifications
Specification [Throttle Position Sensor (TPS)] Throttle angle(°) Output Voltage (V) [Vref=5V] TPS1 TPS2 0 0.5 4.5 10 0.96 4.05 ...

Kia Cee'd JD Service Manual: Crash Pad Lower Panel Repair procedures
Replacement • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. ...