Kia Cee'd: Power Door Locks / Power Door Lock Actuators Repair procedures
| Inspection |
| 1. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
| 2. |
Remove the front door module.
(Refer to Body - "Front Door Module")
|
| 3. |
Disconnect the connector from the actuator.
|
| 4. |
Check actuator operation by connecting power and ground according to
the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
[Central Lock]
[Dead Lock]
|
| 5. |
Check for continuity between the terminals in each switch position according
to the table.
[Central Lock]
|
| 1. |
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
|
| 2. |
Remove the rear door module.
(Refer to Body - "Rear Door Module")
|
| 3. |
Disconnect the connector from the actuator.
|
| 4. |
Check actuator operation by connecting power and ground according to
the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
[Central Lock]
[Dead Lock]
|
| 5. |
Check for continuity between the terminals in each switch position according
to the table.
[Central / Dead Lock]
|
| 1. |
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
|
| 2. |
Disconnect the connector from the actuator.
|
| 3. |
Check actuator operation by connecting power and ground according to
the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
| 1. |
Remove the tailgate open switch bracket (A) after loosening screws.
|
| 2. |
Remove the switch and disconnect the connector from the switch.
|
| 3. |
Check for continuity between the terminals in each switch position according
to the table.
|
Components and components location
Component Location
1. Door lock switch
2. SJB (Smart Junction Box)
3. BCM (Body Control Module)
4. Front door lock actuator
5. Rear door lock a ...
Power Door Lock Relay Repair procedures
Inspection
Diagnosis With GDS
1.
It will be able to diagnose defects of power door lock with GDS quickly.
GDS can operates actuator forcefully, input/output v ...
Other information:
Kia Cee'd JD Service Manual: Engine Control Module (ECM) Repair procedures
Removal
When replacing the ECM, the vehicle equipped with the immobilizer must
be performed procedure as below.
[In the case of installing used ECM]
1) Perform "ECM Neutral mode" ...
Kia Cee'd JD Owners Manual: Closing the sunroof
To close the sunroof glass with the
sunshade
Push the sunroof control lever forward or
full it down.
The sunroof glass will close.
Then to close sunshade
- Press the sunshade control switch(2).
- Push the sunroof control lever forward
or full it down
To stop the sunroof movement at any
...