Kia Cee'd: Heater / PTC Heater (Diesel Engine) Description and operation

The PTC (Positive Temperature Coefficient) heater is installed at the exit or the backside of the heater core.

The PTC heater is an electric heater using a PTC element as an auxiliary heating device that supplements deficiency of interior heat source in highly effective diesel engine. The electric heater heats up the interior by directly heating the air that passes through the heater. The name itself implies that the element has a proportional resistance change sensitive to temperature.

Operation Principle

ECM outputs a PTC ON signal and operates PTC relay 1. Then heater controller operates PTC relay 2 and PTC relay 3 with an interval of 15 seconds.

However, PTC relay 3 can be operated while battery voltage is above 12.4V.

Operating Condition

PTC heater operates according to the following conditions :

 

Mode Control Actuator Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify ...

PTC Heater (Diesel Engine) Repair procedures

Inspection Operating Logic Test (Manual only) Inspect the PTC operation with the confirmation logic below : 1. Entering (1) ...

Other information:

Kia Cee'd JD Service Manual: Repair procedures
Inspection Front Door Lock Module Inspection 1. Remove the front door trim. (Refer to Body - "Front Door Trim") 2. Remove the front door module. (Refer to Body - "Front Door Module") ...

Kia Cee'd JD Owners Manual: Ignition switch position
LOCK The steering wheel locks to protect against theft. The ignition key can be removed only in the LOCK position. When turning the ignition switch to the LOCK position, push the key inward at the ACC position and turn the key toward the LOCK position. ACC (Accessory) The steering whe ...