Kia Cee'd: Heater / PTC Heater (Gasoline Engine) Description and operation
Kia Cee'd JD Service Manual / Heating,Ventilation, Air Conditioning / Heater / PTC Heater (Gasoline Engine) Description and operation
Descriptionddd |
The PTC (Positive Temperature Coefficient) heater is installed at the exit or
the backside of the heater core.
The PTC heater is an electric heater using a PTC element as an auxiliary heating
device that supplements deficiency of interior heat source in highly effective
gasoline engine. The electric heater heats up the interior by directly heating
the air that passes through the heater. The name itself implies that the element
has a proportional resistance change sensitive to temperature.
Operation Principle
Heater control outputs a PTC ON signal and operates PTC relay 1. Then heater
controller operates PTC relay 2 and PTC relay 3 with an interval of 15 seconds.
However, PTC relay 3 can be operated while battery voltage is above 12.4V.
Operating Condition
PTC heater operates according to the following conditions :
• |
Battery voltage : 13.0V or above
|
• |
Engine : 900 rpm or above
|
• |
Ambient temperature and coolant temperature
|
Ambient Temperature |
Coolant Temperature |
PTC Operation |
Below -20°C (-4°F) |
Below 75°C (167°F) |
ON |
5°C (41°F) |
Below 65°C (149°F) |
ON |
7°C (44.6°F) or above |
- |
OFF |
- |
80°C (176°F) or above |
OFF |
PTC Heater (Diesel Engine) Repair procedures
Inspection Operating Logic Test (Manual only) Inspect the PTC operation with the confirmation logic below : 1. Entering (1) ...PTC Heater (Gasoline Engine) Repair procedures
Inspection Operating Logic Test (Manual only) Inspect the PTC operation with the confirmation logic below : 1. Entering (1) ...Other information:
Kia Cee'd JD Service Manual: Parking Assist Sensor Repair procedures
Removal
[Rear Bumper]
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
3.
Disconnect the connector (A) from the ...
Kia Cee'd JD Service Manual: Rear Stabilizer Bar Repair procedures
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque:
88.2 ~ 1 ...