Kia Cee'd: Rear Bumper / Rear Bumper Cover Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper Cover Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	After loosening the mounting screws, then remove the rear combination lamp (A). [5Door] [3Door]

2.	Disconnect the rear combination lamp connector (A).

3.	After loosening the rear bumper side's mounting screws, then disconnect the side's.

4.	Loosen the rear bumper lower mounting clips.

5.	Loosen the rear bumper lower mounting bolts.

6.	Loosen the rear bumper upper mounting screw and clip.

7.	Remove the rear bumper cover (A).

8.	Disconnect the rear bumper main connector (A).

Install in the reverse order of removal.

•	Replace any damaged clips.

•	Make sure the connector is plugged in properly.

Rear Bumper Cover Components and components location

Component Location 1. Rear bumper cover ...

Rear Bumper beam Assembly Components and components location

Component Location 1. Rear bumper beam assembly ...

Other information:

Kia Cee'd JD Service Manual: Power Mosfet (DATC) Repair procedures
Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. Select the control switch to raise the voltage until high speed. ...

Kia Cee'd JD Owners Manual: Lap/shoulder belt
Height adjustment (5 Door and Wagon) ■ Front seat You can adjust the height of the shoulder belt anchor to one of 4 positions for maximum comfort and safety. The height of the adjusting seat belt should not be too close to your neck.You will not be getting the most effective protectio ...