Kia Cee'd: SRSCM / Side Impact Sensor (SIS) Repair procedures
| Removal |
Side Impact Sensor
| 1. |
Disconnect the battery negative cable and wait for at least three minutes
before beginning work.
|
| 2. |
Remove the door scuff trim.
(Refer to Body - "Door scuff trim")
|
| 3. |
Remove the center pillar lower trim.
(Refer to Body - "Center pillar trim")
|
| 4. |
Disconnect the side impact sensor connector (A).
|
| 5. |
Loosen the side impact sensor mounting bolt and remove the side impact
sensor (B).
|
| Installation |
Side Impact Sensor
|
| 1. |
Install the new side impact sensor with the bolt then connect the side
impact sensor connector.
|
| 2. |
Install the center pillar lower trim.
(Refer to Body - "Center pillar trim")
|
| 3. |
Install the door scuff trim.
(Refer to Body - "Door scuff trim")
|
| 4. |
Reconnect the battery negative cable.
|
| 5. |
After installing the Side Impact Sensor, confirm proper system operation:
|
Side Impact Sensor (SIS) Components and components location
Components
...
PAB ON/OFF Switch Description and operation
Description
Driver can control the passenger airbag operating Condition (Enable or Disable)
by using this PAB ON/OFF switch.
Passenger Airbag (PAB) ON/OFF Switch is installed i ...
Other information:
Kia Cee'd JD Service Manual: Smart Parking Assist System Unit Repair procedures
Removal
•
When prying with a flat-tip screwdriver, wrap it with protective
tape, and apply protective tape around the related parts, to
prevent damage.
...
Kia Cee'd JD Owners Manual: User Settings
In this mode there are 3 kinds of the submenu.
WARNING
Do not adjust the User Setting
while driving. You may lose your
steering control and cause severe
personal injury or accidents.
1. Stop the vehicle with the ignition
switch in the ON position or engine
running.
2. Press the ▲ ...