Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Hood / Hood Latch

Kia Rio 2017-2020 YB Service Manual / Body (Interior and Exterior) / Hood / Hood Latch
Components and components location
Component Location

1. Hood lower latch assembly

Repair procedures
Replacement
1.

Remove the front bumper cover.

(Refer to Front Bumper - "Front Bumper Assembly")

2.

Remove the air duct (A).

3.

Disconnect the hood latch cable (A).

4.

Disconnect the hood latch connector (A).

5.

Remove the hood lower latch assembly (A) after loosening the bolts.

Tightening torque :

7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft)

6.

Install in the reverse order of removal.

  

Make sure the hood latch release cable is connected properly.

Make sure the hood locks/unlocks and opens/closes properly.

Adjust the latch alignment.

Hood Latch Release Handle
Components and components location Component Location 1. Hood latch release handle Repair procedures Replacement ...
Interior Trim
Components and components location Components 1. Front pillar trim assembly 2. Front door scuff trim assembly 3. Center pillar upper trim assembly 4. Rear pil ...
Other information:

Kia Rio 2017-2020 YB Service Manual: Sunroof Motor


Repair procedures Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly") 3. Remove the glass motor (A) after loosening the mounting ...

Kia Rio 2017-2020 YB Owners Manual: Rear view monitor system


Rear View Monitor function ■ Type A ■ Type B Rear View Monitor system will activate with the ignition switch on and the shift lever in the R (Reverse) position. Please note that during initial start up, the rear view monitor may not display instantly due to the audio system booting ...
Copyright © www.kiamanual.com 2020-2021