Kia Rio: Body Electrical System / Ignition Switch

Kia Rio 2017-2020 YB Service Manual / Body Electrical System / Ignition Switch

Repair procedures

Inspection

1.	Disconnect the key warning switch connector (A) and ignition switch connector (B) from the steering column.

2.	Check for continuity between the terminals.

3.	If continuity is not specified, replace the switch.

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel")

3.	Remove the steering column upper and lower shroud panel. (Refer to Body - "Steering Column Shroud Panel")

4.	Remove the multifunction switch. (Refer to Body Electrical System - "Multifunction Switch")

5.	Remove the ignition switch connector (A) and key warning / immobilizer connector (B).

6.	Insert key and turn it to ACC position.

7.	Pushing lock pin (A) with the awl.

Remove the key lock cylinder (A).

B : Key warning switch

C : Ignition switch connector

9.	Remove the ignition switch (A) after loosening the mounting bolts.

Installation

•	Do not reuse the shear bolts.

•	When installing the new shear bolts to the ignition switch assembly, tighten the shear bolts until its head is cut off.

1.	Install the ignition switch.

2.	Install the key lock cylinder.

3.	Connect the ignition switch connector and key warning / immobilizer connector.

4.	Install the multifunction switch.

5.	Install the steering column upper and lower shroud panel.

6.	Install the crash pad lower panel.

7.	Connect the negative (-) battery terminal.

Horn

Components and components location Component Location 1. Horn switch 2. Horn relay 3. Horn 4. Clock spring Repair procedures Removal ...

Immobilizer System

Schematic diagrams Circuit Diaram Description and operation Description The immobilizer system will disable the vehicle unless the proper ignition key is used, in add ...

Other information:

Kia Rio 2017-2020 YB Service Manual: Parking Assist Sensor

Components and components location Components Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper assembly. (Refer to Body - "Rear Bumper Assembly") 3 ...

Kia Rio 2017-2020 YB Owners Manual: Tire specification and pressure label, Engine number

Tire specification and pressure label The tires supplied on your new vehicle are chosen to provide the best performance for normal driving. The tire label located on the driver's side center pillar gives the tire pressures recommended for your vehicle. Engine number ■ Gamma II 1.6L MPI ...