Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Blower Resistor (MANUAL) Replacement - Blower - Heating,Ventilation, Air Conditioning - Kia Rio UB 2012-2020 Service ManualKia Rio: Blower Resistor (MANUAL) Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the connector (A) and then remove the blower resistor (B) after loosening the mounting screws.


3.
Install in the reverse order of removal.
Blower Resistor (MANUAL) Inspection
1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replac ...
Power Mosfet (FATC) Inspection
1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of blower motor. 3. ...
See also:

Disassembly
Engine removal is required for this procedure. (Refer to Engine and transaxle assembly removal in this group) 1. M/T : Remove the fly wheel. 2. ...

BJ Boot Components
1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 1 ...

Transaxle Control Module (TCM) Inspection
TCM Problem Inspection Procedure 1. TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis ground using the backside of TCM harness connector as TCM side c ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts