Kia Rio: Component(2)

Component(1)

※ Installation order : A → B → C → D → E 1. Steering column shaft 2. Lighting switch 3. Wiper and washer switch 4. Screw 5. Steering angle ...

Inspection

Lighting Switch Inspection With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the mul ...

See also:

5Door Front Body A
Hood hinge mounting hole (Ø11) Fender apron upper member tooling hole (Ø6.6) Front shock absorber hou ...

Blower Resistor (MANUAL) Replacement
1. Disconnect the negative (-) battery terminal. 2. Disconnect the connector (A) and then remove the blower resistor (B) after loosening th ...

Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog signal propo ...