Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Condenser Replacement - Air Conditioning System - Heating,Ventilation, Air Conditioning - Kia Rio UB 2012-2020 Service ManualKia Rio: Condenser Replacement

1.
Recover the refrigerant with a recovery/recycling/charging station.
2.
Disconnect the negative (-) battery terminal.
3.
Remove the front bumper.
(Refer to BD group - “Front Bumper”)
4.
Remove the air guard (A).


5.
Disconnect the discharge line (A) and liquid line (B) from the condenser.


6.
Remove the condenser (A) from the radiator.


7.
Install in the reverse order of removal.

     
If you're installing a new condenser, add refrigerant oil (PAG OIL).
Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage.
Be careful not to damage the radiator and condenser fins when installing the condenser.
Charge the system, and test its performance.
Condenser Inspection
1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air. If bent, gently bend them using a screwdrive ...
Receiver-Drier Replacement
1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with L wrench (A). Tightening torq ...
See also:

Starter: Specification
Starter [Non-ISG type] Item Specification Rated voltage 12 V, 0.9 kW The number of pinion teeth 10 Performance [No-load, 1 ...

Rear Washer Motor Inspection
1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. 2. Remove the front bumper cover. (Refer to t ...

Ignition Coil: Circuit Diagram
...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts