Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Fender Replacement - Exterior - Body (Interior and Exterior) - Kia Rio UB 2012-2020 Service ManualKia Rio: Fender Replacement


     
When removing and installing the fender, an assistant is necessary.
Be careful not to damage the fender and body.
When removing the clips, use a clip remover.
1.
Remove the front bumper cover.
(Refer to the BD group – “Front bumper”)
2.
Remove the head lamps.
(Refer to the BE group – “Head Lamps”)
3.
Using a screwdriver or remover, remove the front pillar trim (A).


4.
Disconnect the tweeter speaker connector (A).


5.
Loosen the delta glass mounting nuts.

Tightening torque :
3.9 ~ 4.4 N.m (0.4 ~ 0.45 kgf.m, 2.9 ~ 3.3 lb-ft)


6.
Remove the delta glass (A).


7.
Loosen the wheel guard (A) mounting screws.


8.
After loosening the mounting screws, then remove the front bumper side mounting bracket (A).


9.
After loosening the mounting bolts, then remove the fender assembly (A).


10.
Installation is the reverse of removal.
Exterior
...
Hood Replacement
Hood Assembly Replacement    • When removing and installing the hood, an assistant is ...
See also:

Steering Column and Shaft Disassembly
Key lock assembly 1. Make a groove on the head of special bolts (A) with a chisel. 2. Loosen the special bolt using a screw driver a ...

Starter: Circuit Diagram
...

TPMS Receiver Operation
1. General Function A. Auto-learn takes place only once per Ignition cycle. B. On successful compl ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts