Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: TPMS Receiver Operation - Tire Pressure Monitoring System - Suspension System - Kia Rio UB 2012-2020 Service ManualKia Rio: TPMS Receiver Operation

1.
General Function
A.
Auto-learn takes place only once per Ignition cycle.
B.
On successful completion, 4 road wheel sensor ID's are latched into memory for monitoring.
C.
Until Auto-learn completes, previously learned sensors are monitored for under inflation / leak warnings.
2.
General Conditions to Learn New Sensors:
A.
Receiver must determine that it is confident that sensor is not temporary:
1)
Uses vehicle speed.
2)
Uses confidence reduction of previously learned sensors.
B.
Typical time at driving continuously over 12.4 mph(20 kph) to learn a new sensor is up to 20 minutes.
3.
General Conditions to Un-Learn a sensor that is removed:
A.
It takes less than 20 minutes at 12.4 ~ 18.6 mph(20 ~ 30kph).
B.
Confidence reduction is dependent on time which vehicle is driven at speed greater than or equal to 12.4 mph(20 kph).
TPMS Receiver Description
1. Mode (1) Virgin State A. The receiver as a sole part is shipped in this state. ...
TPMS Receiver Replacement
   When the receiver first arrives for replacement: 1) It will be in Virgin State. ...
See also:

Room Lamp Installation
Room Lamp 1. Install the room lamp assembly after connecting the room lamp connector. 2. Install the room lamp lens. ...

Description
Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge control solen ...

Engine Number
1. Engine fuel - G : Gasoline 2. Engine range - 4 : 4 cycle 4 cylinder 3. Engine developme ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts