Rio Car Manuals
Technical Info

Kia Rio: Fuel Pump Inspection

[Fuel pump]

1.	Turn ignition switch OFF and disconnect the negative (-)battery cable.

2.	Remove the fuel pump assembly.

3.

Check motor operation by fuel pump connector (A) connecting power(No.2) and ground(No.4)

Pin No.	discription
1	Fuel sender signal
2	Fuel pump (+)
3	Fuel sender ground
4	Fuel pump (-)

[Fuel sender]

1.

Using an ohmmeter, measure the resistance between terminals 1 and 3 of sender connector (A) at each float level.

Pin No.	discription
1	Fuel sender signal
2	Fuel pump (+)
3	Fuel sender ground
4	Fuel pump (-)

2.

Also check that the resistance changes smoothly when the float is moved from "E" to "F".

Position	Resistance (Ω)	Capacity (ℓ)
E	197 ~ 203	2.8
1/2	64.2 ~ 68.2	22.3
F	6 ~ 10	41.8

Fuel Pump Installation

1. Installation is reverse of removal. Fuel pump plate cover installation bolt : 1.96 ~ 2.94 N.m (0.2 ~ 0.3 kgf.m, 1.44 ~ 2.17 lb- ...

Fuel Filter Replacement

1. Remove the fuel pump (Refer to “Fuel Pump” in this group). 2. Disconnect the electric pump wiring connector (A) and the fuel sender conn ...

See also:

Description
Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehic ...

Special Service Tools
Tool (Number and name) Illustration Use 09411-1P000 Clutch disc guide Installation of the clutch disc. ...

Front Hub / Knuckle Disassembly
1. Remove the snap ring (A). 2. Remove the hub assembly from the knuckle assembly. (1) Install the ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts