Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Installation - Injector - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2020 Service ManualKia Rio: Installation


1.
Combustion seal
2.
Rubber washer
3.
Support disc
4.
O-ring

     
Do not reuse the used injector fixing clip.

     
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

     
Apply engine oil to the injector O-ring.
Do not reuse the used injector O-ring.

     
Do not reuse the used bolt.

     
When inserting the injector, be careful not to damage the injector tip.

     
Do not reuse the support disc.
Do not reuse the injector rubber washer.
When replacing the rubber washer, the steal plate (A) part should be faced the cylinder installation part and the rubber plate (B) part should be faced the injector body part.



     
Do not reuse the combustion seal.
1.
Installation is reverse of removal.
Removal
   In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be inju ...
Replacement
The injector combustion seal should be replaced new one to prevent leakage after removing the injector. 1. Remove the combustion seal (A) with a wire cutter. ...
See also:

Hood switch Removal
1. After loosening the mounting bolts and connector, then remove the hood switch (A). ...

Transmitter Code Registration (Using GDS)
1. Connect the DLC cable of GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on GDS. 2. ...

Intake Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuato ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts