Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Removal 
 - Injector - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2020 Service ManualKia Rio: Removal


     
In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. Before repairing the high pressure system, be sure to release the residual pressure in fuel line as step 2 in below procedure.
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line").

     
When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
3.
Remove the delivery pipe & injector assembly (Refer to "Delivery Pipe" in this group).
4.
Remove the connector (A) and the fixing clip (B), and then separate the injector from the delivery pipe.


Inspection
1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the inject ...
Installation
1. Combustion seal 2. Rubber washer 3. Support disc 4. O-ring ...
See also:

Description
The Evaporative Emission Control System prevents fuel vapor stored in fuel tank from vaporizing into the atmosphere. When the fuel evaporates in the fuel tank, the vapor passes through vent h ...

Valve Body Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

Foot Actuator (With Auto Defogging System) Inspection
1. Turn the ignition switch OFF. 2. Disconnect the foot connector. 3. Verify that the foot actuator operates to ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts