Kia Rio: Valve Body Removal

1.	Remove the battery and the battery tray. (Refer to "Charging system" in EE group.)

Remove the under cover (A).

Tightening torque:

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

3.	Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug. (Refer to "Hydraulic system (Fluid)" in this group)

Remove the valve body cover (B).

Tightening torque:

13.7 ~ 15.7 N.m (1.4 ~ 1.6 kgf.m, 10.1 ~ 11.6 lb-ft)

5.	Remove thd air breather hose (A).

Remove the plate and the detent spring (A) after removing the bolt.

Tightening torque:

11.8 ~ 15.7 N.m (1.2 ~ 1.6 kgf.m, 8.7 ~ 11.6 lb-ft)

Remove the bolt (3ea) after disconnecting the solenoid valve (B) connector and the oil temperature sensor connector (A).

Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Remove the valve body assembly (A).

Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Valve Body Components Location

1. PCV adjust screw 2. Solenoid valve 3. Oil temperature sensor 4. Accumulator 5. Low & reverse brake(LR/B) pressure flow hole 6. Under drive brake (UD/B) pressur ...

Valve Body Installation

1. Installation is the reverse of removal. After replacement or reinstallation procedure of ...

Kia Rio: Valve Body Removal

Valve Body Components Location

Valve Body Installation

See also: