Kia Rio: Measurement Method
| Projected Dimensions |
|
1. |
These are the dimensions measured when the measurement points
are projected into the reference plane, and are the reference dimensions
used for body alterations.
|
|
2. |
If the length of the tracking gauge probes is adjustable, make
the measurement by lengthening one probe by the amount equivalent to
the difference in height of the two surfaces.
|
| Actual-Measurement Dimensions |
|
1. |
These dimensions indicate the actual linear distance between measurement
points, and are the reference dimensions for use if a tracking gauge
is used for measurement.
|
|
2. |
Measure by first adjusting both probes to the same length (A=A').
Check the probes and gauge itself to make sure there is
no free play.
|
| Measurement Point |
|
1. |
Measurements should be taken at the hole center.
|
1.
Basically, all measurements in this manual are taken with a tracking
gauge.
2.
When a measuring tape is used, check to be sure there is ...
Hood hinge mounting hole (Ø11)
Fender apron upper member tooling hole (Ø6.6)
Front shock absorber hou ...
See also:
Multimedia Jack Circuit Diagram
...
Radiator: Description
[Air conditioning type]
The cooling fan operates in 2 stages (HIGH/LOW). The engine control module
(ECM) controls the cooling fan according to the coolant temperature, vehicle
speed and A ...
Tilting the sunroof
To open the sunroof, push the sunroof control lever upward until the sunroof
moves to the desired position.
To close the sunroof, push the sunroof lever forward or pull downward until the
sunroof ...
General
4Door Front Body A