Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Removal 
 - Specification - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2020 Service ManualKia Rio: Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the resonator and the air intake hose (Refer to “Intake And Exhaust System” in EM group).
3.
Disconnect the ETC module connector (A).


4.
Disconnect the coolant hoses (A).


5.
Remove the installation bolts, and then remove the ETC module (A) from the engine.


Inspection
Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TP ...
Installation
   • Install the component with the specified torques. • ...
See also:

Rear Hub - Carrier Inspection
1. Check the hub for cracks and the splines for wear. 2. Check the brake disc for scoring and damage. 3. C ...

Specification
Item Specification Coil Resistance (Ω) 19.8 ~ 20.8 [20°C(68°F) ...

Removal
Rear Disc Brake Type    The parking brake cables must not be bent or distorted. This will lead to stiff operat ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts