Using Voice Recognition
Starting Voice Recognition
Shortly press the
key on the steering wheel.
Say a command
If prompt feedback is in [ON], then the system will say “Please say a command after the beep (BEEP)”
Contact List Best Practices
1)Do not store single-name entries (e.g., “Bob”, “Mom”, “Kim”, etc.). Instead, always use full names (including first and last names) for all contacts (e.g., use “Jacob Stevenson” instead of “Dad”).
2)Do not use abbreviations (i.e., use “Lieutenant” instead of “Lt.” or “Sergeant” instead of “Sgt.”).
3)Do not use acronyms (i.e., use “County Finance Department” instead of “CFD”).
4)Do not use special characters (e.g., “@”, “hyphen -“, “asterisk *”, ampersand &”).
5)If a name is not recognized from the contact list, change it to a more descriptive name (e.g., use “Grandpa Joseph” instead of “Pa Joe”).
Skipping Prompt Messages
While prompt message is being stated
Shortly press
the key on
the steering remote controller (under 0.8 seconds)
The prompt message is immediately ended and the beep tone will sound. After the “beep”, say the voice command.
Re-starting Voice Recognition
While system waits for a command
Shortly press the
key on the
steering remote controller (under 0.8 seconds)
The command wait state is immediately ended and the beep tone will sound. After the “beep”, say the voice command.
Engine Oil: Oil And Filter Replacement
•
Prolonged and repeated contact with mineral oil will result
in the removal of natural ...
Active ECO system
Active ECO operation
Active ECO helps improve fuel efficiency by controlling the engine and transaxle.
But fuel-efficiency can be changed by the driver's driving habits and road conditions.
...
Seat Heater Switch Installation
1.
Install the seat heater switch.
2.
Install the console assembly.
3.
Connect the battery (-) terminal.
...