Kia Rio: Water pump: Troubleshooting
Water Pump
Symptoms
|
Possible Causes
|
Remedy
|
Coolant leakage
|
|
|
From the bleed hole of the water pump
|
Visually check
|
|
|
Check leaks after about ten-minute warming up.
|
|
|
If coolant still leaks, replace a water pump.
|
|
|
If leakage stops, reuse the water pump (Do not replace
the pump with a new one).
|
|
|
From gaskets or bolts
|
|
|
Check the tightening of the water pump mounting bolts.
|
|
|
Retighten the mounting bolts.
|
|
|
Check damage of gaskets or inflow of dust.
|
|
|
Replace the gasket and clean dust off.
|
|
|
From outer surface of water pump
|
|
|
Check the material or any cracks of the water pump.
|
|
|
Poor material. If any crack found, replace the water pump.
|
Noise
|
|
|
From bearings
|
|
From mechanical seals
|
|
Impeller interference
|
Inspection with a stethoscope
|
|
|
After starting the engine, check noise with a stethoscope.
|
|
|
If there is no noise, reuse the water pump(do not replace
it).
|
|
|
If there is any noise from the water pump, remove the
drive belt and recheck.
|
Inspection after removing a drive belt
|
|
|
After removing a water pump and a drive belt, check noise
again.
|
|
|
If there is noise, reuse the water pump. Check other drive
line parts.
|
|
|
If there is no noise, replace the water pump with a new
one.
|
Inspection after removing a water pump
|
|
|
After removing a water pump and a drive belt, check noise
again.
|
|
|
If there is any interference between them, replace the
water pump with a new one.
|
Overheating
|
|
|
Damaged impeller
|
|
Loosened impeller
|
Loosened impeller
|
|
|
Corrosion of the impeller wing
|
|
|
Check engine coolant.
|
|
Poor coolant quality / Maintenance check
|
|
|
Impeller seperation from the shaft
|
|
|
Replace the water pump.
|
1.
Check each part for cracks, damage or wear, and replace the coolant
pump assembly if necessary.
2.
Check the bearing for damage, abnorma ...
1. Cooling fan & reservoir tank assembly
2. Radiator lower hose
3. Air guard
4. Upper cover
5. Radiator upper hose
6. Filler neck
...
See also:
Operation Principle
In the ISG mode, if the power of an audio system turns
OFF by drawdown while Auto ...
Starter: Circuit Diagram
...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV termina ...