Kia Rio: AGM Battery: Adjustment
| Battery charging |
In general, vehicle battery charging system has three forms.
|
1. |
Constant current charge: The battery voltage gradually rises by
charging with setting a constant current. If charging current and time
are not managed correctly, the battery is over-charged, therefore charging
should be stopped after confirming the completion of charging.
|
| A.
General charge: Charging the battery for a long time with
low current
|
| B.
Quick charge: Charging the battery for a short time with
high current
|
|
2. |
Constant voltage charge: The battery charge current is gradually
reduced by charging with setting a constant voltage.
|
|
3. |
Constant current-Constant voltage charge: Charging with constant
current and voltage to protect the battery damage.
|
|
(1) |
Initial Stage: Charging with constant current
|
|
(2) |
Last Stage: Charging with constant voltage
Refer to the instruction manual provided by the
battery charger equipment manufacturers for detailed
charging procedures and precautions.
|
AGM battery should be charged with constant voltage or constant current-constant
voltage in order to minimize performance degradation due to the charging.
If charging the battery with constant current, overcharging may occur.
It can cause damage to the internal battery and will give an adverse effect
on battery life.
Do not charge with more than 14.8V or quick charge mode.
Charging voltage / time :
14.7V [68°F ~ 86°F (20°C ~ 30°C)] / approximately 24 hours
The minimum charge voltage :
14.4V [68°F ~ 86°F (20°C ~ 30°C)]
The maximum charging voltage :
14.8V [68°F ~ 86°F (20°C ~ 30°C)]
|
Battery temperature should be maintained at about 68°F ~ 86°F
(20°C ~ 30°C) during charging of the battery.
If the battery is charged directly at the battery terminals on
vehicles with battery sensor, misinterpretations of battery condition
and under certain circumstances also unwanted Check Control messages
or fault memory entire can occur.
After recharging finished, let the battery stand for over 10 hours
with normal temperature for battery stabilization.
Item
Specification
Model type
AGM 70L-DIN
Capacity [20HR/5HR] (AH)
70/56
Cold Cranking Amperage (A)
760 (SAE) / 610 (EN)
...
1.
Remove the battery.
(1)
Disconnect the battery terminals (A).
Tightening torque
(+ ...
See also:
Shift Lever Adjustment
1.
In neutral position, disjoin select cable (A) from shift lever
assembly pin (B).
2.
Disconnect select adjuster (A) to an arrow.
...
Description of ESC
Electronic Stability Control (ESC) recognizes critical driving conditions,
such as panic reactions in dangerous situations, and stabilizes the vehicle
by wheel-individual braking and engine c ...
Specification
Air Conditioner
Item
Specification
Compressor
Type
DVE12 (Externally Controlled Variable Swash Plate Type)
Oil type & Capacity
PAG ...
AGM Battery: Specification
AGM Battery: Removal and Installation