Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Ignition Switch Assembly Removal - Button Engine Start System - Body Electrical System - Kia Rio UB 2012-2020 Service ManualKia Rio: Ignition Switch Assembly Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds.
(Refer to the ST group - "Steering column")
3.
Disconnect the ignition switch connector (B) and the key switch connector (A) from under the steering column.


4.
If it is necessary to remove the key lock cylinder (A), remove the key lock cylinder after pushing lock pin with key ACC.


Ignition Switch Assembly Inspection
1. Disconnect the ignition switch connector (B) and key switch connector (A) from under the steering column. 2. Check for continui ...
Ignition Switch Assembly Installation
1. Install the key lock cylinder.    When assembling, the key must be insert ...
See also:

Shift Lever Adjustment
Adjusting the control cable 1. Set room side AT lever(shift lever) and automatic transaxle side manual control lever to "N" position. ...

Passenger Airbag (PAB) ModuleInstallation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable from battery and wait for at least thirty seconds bef ...

Removal
   In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be inju ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts