Kia Rio: Body (Interior and Exterior) / Rear Door

Kia Rio 2017-2020 YB Service Manual / Body (Interior and Exterior) / Rear Door

Components and components location

Components

1. Rear door trim complete
2. Rear door complete
3. Rear door belt inside weatherstrip
4. Rear door belt outside weatherstrip

5. Rear door trim seal
6. Rear door body side weatherstrip
7. Rear door side weatherstrip
8. Rear door hinge

Repair procedures

Adjustment

Glass Adjustment

Check the glass run channel for damage or deterioration, and replace them if necessary.

1.	Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim")

2.	Remove the door pull handle mounting support (A) after loosening the screws.

3.	Disconnect the rear door speaker connector (A), and then remove the wiring mounting clips.

4.	Remove the rear door trim seal (A).

5.	Carefully move the rear door window glass (A) until the glass mounting bolts are visible, then loosen them.

6.	Check that the glass moves smoothly.

Door Striker Adjustment

Make sure the door latches securely without slamming it. If necessary adjust the striker (A): The striker nuts are fixed. The striker can be fine adjusted up or down, and in or out.

Loosen the screws (B) just enough for the striker to move.

Tightening torque :

16.7 - 21.6 N·m (1.7 - 2.2 kgf·m, 12.3 - 15.9 lb·ft)

2.	Tap on the striker with a plastic hammer to adjust the striker. The striker will not move much, but will give some adjustment.

3.	Hold the outer handle out, and push the door against the body to be sure the striker allows a flush fit. If the door latches properly, tighten the screws and recheck.

Door Position Adjustment

After installing the door, check for a flush fit with the adjacent body panels, then check for equal gaps between the front, rear, and bottom, door edges and the body. Check that the door and body edges are parallel. Before adjusting, replace the mounting bolts.

1.	Check that the door and body edges are parallel.

2.	Place the vehicle on a firm, level surface when adjusting the doors.

Adjust at the hinges (A) :

•	Loosen the door mounting bolts slightly, and move the door in or out until it aligns flush with the body.

•	Loosen the hinge mounting bolts slightly, and move the door backward or forward, up or down as necessary to equalize the gaps.

•	Place a shop towel on the jack to prevent damage to the door when adjusting the door.

Tightening torque :

(B) : 9.8 - 19.6 N·m (1.0 - 2.0 kgf·m, 7.2 - 14.5 lb·ft)

4.	Grease the pivot portions of the hinges indicated by the arrows.

5.	Check for water leaks.

Rear Bumper beam Assembly

Components and components location Component Location 1. Rear bumper beam assembly Repair procedures Replacement ...

Rear Door Trim

Components and components location Component Location 1. Rear door trim Repair procedures Replacement & ...

Other information:

Kia Rio 2017-2020 YB Service Manual: Trunk Lid

Repair procedures Adjustment (5Door) 1. After loosening the tailgate hinge (A) mounting bolts, adjust the tailgate by moving it up and down, or right and left. 2. Adjust the tail gate height by turning the tailgate overslam bump ...

Kia Rio 2017-2020 YB Service Manual: Fly Wheel

Repair procedures Removal 1. Remove the manual Transaxle. (Refer to Manual Transaxle System - "Manual Transaxle") 2. Remove the clutch cover. (Refer to Clutch System - "Clutch Cover and Disc") 3. ...